Trapped Air in Cream and Lotion: How Vacuum Degassing Works Inside an Emulsifying Mixer
2026/11/04
A cream that looks flawless in a 2 L beaker can reach the filling line full of pinholes. The culprit is usually not the formula but the air the process put into it. Vacuum degassing removes that air — and it is the step buyers most often leave under-specified when comparing quotations.

What Trapped Air Really Costs
Air is not only a cosmetic defect. Bubbles weaken the emulsion's internal structure, so a batch that tests well on day one can thin out in storage. They distort volume too: a batch carrying 3% entrained gas fills correctly by weight but short by volume, surfacing later as check-weight rejections. And every bubble is a small oxygen reservoir, so vitamin C derivatives and unsaturated oils degrade faster around it.
Entrained Air and Dissolved Air Are Different Problems
Entrained air is mechanically mixed in: powder dropped through an open manway, a vortex at the tank wall, cavitation at the homogenizer head. In a 50,000 cP cream a 200 µm bubble needs hours to rise 30 cm — longer than the batch exists. Dissolved air is held by pressure and comes out of solution when the batch cools. Vacuum handles both. Pulling the headspace to -0.08 to -0.098 MPa expands entrained bubbles until they rupture, while the lower partial pressure draws dissolved gas out. Most cosmetic emulsions run at -0.09 MPa; deeper buys little and works the seals harder.
Where Vacuum Earns Its Cost
Three moments matter. Charging: drawing powder and both phases through sealed lines under negative pressure avoids the turbulence of open loading — published trials report around 70% less initial bubble volume, with residual gas below 0.05%. Homogenization: run the vacuum too shallow at 2,800–3,500 rpm and cavitation at the shear head creates microbubbles faster than the pump clears them. Hold: five to ten minutes of quiet vacuum before cooling lets residuals escape; one production case cut gas content from 3.2% to 0.08% in 15 minutes at -0.09 MPa.
Why Viscosity Changes the Answer
Degassing time depends on the product, not the pump. Above roughly 50,000 cP bubbles cannot rise at all and must be ruptured in place, so the hold gets longer and the scraper slower. Very low fill levels degas quickly but risk a surface vortex; filling beyond 75–80% can pull product into the vacuum line.
A Buyer's Checklist Before You Sign
Specify working pressure at the vessel headspace, not the pump's ultimate vacuum — they are different numbers. Ask for a vacuum hold test on an empty vessel to expose leaks at the lid gasket, sight glass, valve seats and mechanical seal. Confirm the exhaust ducting route. Then ask the supplier to prove degassing time on your own formulation, not on water.
SINAEKATO builds its vacuum emulsifying mixer with vacuum defoaming around these points: -0.09 MPa working vacuum, SS316L product-contact surfaces, PTFE scraper blades and a bottom homogenizer, with PLC recipes that lock the vacuum, temperature and speed sequence per product. With more than 30 years in emulsifying equipment and a 10,000 m² base in Gaoyou, Jiangsu, the company trial-runs formulations for buyers from over 60 countries before a line is specified. Where particle-size uniformity shares priority with degassing, the vacuum emulsifying mixer with an advanced mixing system uses the same vessel platform with a different agitator combination.